Lenovo ThinkStation P320 Hardwarebedienungsanleitung Seite 118

6. Position the flex module cover on the flex module. Ensure that the rail guides on the bottom of the
cover engage the rails on the flex module. Then, push the cover to the front of the flex module until
it snaps into position.
Figure 41. Reinstalling the flex module cover
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 166.
eSATA connector or IEEE 1394 connector
To install or replace an eSATA connector or IEEE 1394 connector in the flex module, do the following:
1. Remove the flex module out of the chassis. See "Optical drive" on page 104.
2. Lift the clip on the rear of the flex module and slide the flex module cover to the rear to remove the cover.
Figure 42. Removing the flex module cover
3. If you are replacing an eSATA connector or IEEE 1394 connector, do the following:
a. Disconnect the eSATA connector or IEEE 1394 connector cable from the system board. See "Parts
on the system board" on page 34.
110
P320 Hardware Maintenance Manual