Attaching a cable lock
A cable lock can be used to secure devices, such as the keyboard and the mouse, by locking the device
cables to your computer. The cable lock attaches to the cable-lock slots on the rear of your computer.
To attach a cable lock, do the following:
1. Insert the clip
1
into the cable-lock slot
2. Pull the cables you want to lock through the dents in the cable lock.
3. Press the clip
2
into the cable-lock slot
Figure 10. Installing a cable lock
Viewing and changing security settings in the Setup Utility program
To view and change security settings in the Setup Utility program, do the following:
1. Start the Setup Utility program. See "Starting the Setup Utility program" on page 61.
2. Select Security.
3. Follow the instructions on the right side of the screen to view and change security settings. You can
refer to "Using the Setup Utility program" on page 61 to get basic information about some major
security settings.
4. To save settings and exit the Setup Utility program, press F10 or Fn+F10 (depending on the keyboard).
Then, select Yes in the window displayed, and press Enter.
Using passwords and Windows accounts
You can use BIOS passwords and Windows accounts to prevent unauthorized access to your computer and
data. To enable the BIOS passwords and the Windows accounts, do the following:
1. Start the Setup Utility program. See "Starting the Setup Utility program" on page 61.
4
.
3
until it snaps into position.
57
.
Chapter 5
Security