Coltene BioSonic UC150 Benutzerhandbuch Seite 7

• PLUG IN THE UNIT. Attach the UC150 electrical cord at the lower back of the unit and plug into a
three-wire grounded AC outlet (in accordance with local regulations)
recommended that the unit be plugged into a Ground Fault Circuit Interrupter (GFCI) outlet.
Installation instructions for recessing unit:
• Tools Required:
- Electric Drill
- Drill bit to drill a hole large enough to accept your reciprocating saw blade
- Reciprocating saw and blade
NOTE: This Ultrasonic Cleaner must be installed by an experienced equipment manager or
licensed contractor. Be sure to follow local building codes.
NOTE: Before you begin please read and understand the safety instructions provided by the
manufacturer of the tools required for installation.
• Select the desired location for the cleaner. You will need at least 19 cm (7.5 inches) clear vertical
space below the top of the counter to accommodate the tank enclosure. The countertop must
be flat and level. Make sure that you are not selecting a location which will interfere with
drawers or vertical partitions between cabinets.
• Tape the enclosed template down to the counter top in the desired location. Make sure that the
"front of the unit" is closest to the user.
• Cut along the "cut line" with a jigsaw or other reciprocating saw.
• Clean away dirt or sawdust around the opening, and remove scrap wood.
• Attach the rubber gasket on the housing for better seating between bezel and counter top.
• Lower unit into opening. Be sure that the printed BioSonic logo on the housing faces the user.
(Figure 11)
• The hose supplied with the UC150 will allow you to dispose of the waste in accordance with
your local, state and/or federal regulations.
• Opening the drain valve will allow you to empty the solution into a waste storage container for
disposal in accordance with your local, state and/or federal regulations.
Power should not be supplied to the unit until all interconnections
between the display and tank enclosure and any accessories are securely
WARNING!
connected.
(Failure to comply
may result in per-
This unit must be properly grounded. Failure to properly ground unit may
sonnel injury and/
or equipment
result in serious injury.
damage.)
(Figure 9). It is
7