CAME Z Serie Bedienungsanleitung Seite 4

E1 flashes for 5 seconds before beginning
the procedure;
- Command-type selection :
- « - -
OPEN STOP CLOSE
transmitter;
- « - » by button and transmitter;
OPEN CLOSE
- « » by transmitter.
OPEN ONLY
Accessories which can be connected to
this unit
- Courtesy light , on terminals E1-E3. The
lamp that lights the manoeuvring zone, after
an open command, remains lit for a fixed
time of 2 minutes and 30 seconds;
- Open gate pilot, lampon terminals 10-5 with
dip 9 to ON. Lamp that indicates the door's
open position and goes off when the door
closes that activates the limit switch;
Flashing lamp indicating the door's
movement, on terminals W-E1. It flashes
during the phase of door opening and
closing;
- Electric lock 24V , connect it to 10-5 with
dip 9 to OFF;
- "AF" radiofrequency board (see table on
pag. 22) for remote control.
Adjustments
- Automatic closure time;
- Sensitivity of obstacle's detection.
Important! Disconnect the unit from
the main power lines before carrying out
any operation inside the unit.
-4-
- » by button and
STOP