Parkside PSHL 2 B1 Bedienungs- Und Sicherheitshinweise Seite 60

Initial use
Table for setting the darkening shades
1,5 6 10
Grind
SMAW 8
MAG
TIG /
8
GTAW
MIG
(heavy)
MIG
(light)
PAC
PAW 4 5
SMAW: welding with coated
electrodes
MIG (heavy): MIG welding heavy metals
MIG (light): MIG welding light metals
and alloys
TIG / GTAW: welding with inert gases
MAG: welding with metal active
gass
Test procedure
You can use the test button
„ „
whether the welding helmet's darkening
feature is working properly.
Bring the viewing panel closer to an ex-
„ „
ternal light source with a value of more
than 40 W and examine whether or
not the screen darkens or illuminates.
To do so, turn the darkening control
clockwise from "Grind" to the next posi-
tion. This sets the filter to auto-darkening
mode.
If you turn the darkening control
„ „
ticlockwise back to "Grind", the filter's
auto-darkening feature is once again
deactivated.
60 GB/MT
Arc current (ampere)
15 30 40 60 70 100 125 150 175 200 225 250 300 350 400 450 500
Grinding function - automatic dimming not active
9
8 9
9 10
9
10
9
6 7 8
to check
11
9
an-
9
10 11 12
10 11
11 12
10 11
11
10 11 12
9 10 11
PAC: plasma cutting
PAW: plasma welding
Grind: Grinding function: Automatic dim-
ming not active. Only use the setting
if you do not use welding helmet for
welding.
Change UV filter
Press the clip
„ „
the UV filter / solar cell. (see Fig. C).
Subsequently you can remove the filter
(see Fig. C).
Then remove the darkening control
„ „
from the exterior of the welding helmet
by simply pulling it away, and unscrew
the nut that is located beneath it (see fig-
ure D).
Once you have removed the nut from the
„ „
thread, you can completely remove the fil-
ter from the welding helmet. (see figure D)
13
12 13
13
12 13 14
12 13 14
13
12
downwards to change
16
600
14
14
9