Initial Use - Parkside PSHL 2 B1 Bedienungs- Und Sicherheitshinweise

ly after the letter for the impact
intensity, i. e. FT, BT or AT. If the
letter for the impact intensity is
not followed by the letter T, the
eye protection may only be used
against high-speed particles at
room temperature.
z Initial use
Note: Only use the welding helmet with the
rear pane mounted
Note: Keep the UV filter's sensors
and clear.
After opening the package, immediately
check to ensure that the package contents
are complete and undamaged. Contact your
dealer immediately if the package contents
is incomplete or has any defects. Do not use
the device if it is defective
Check that the welding helmet and the
protective screen are intact before each use.
If the protective screen has scratches, cracks
or irregularities, it must be replaced before
use, as serious injuries may occur otherwise.
Remove the protective film from the in-
„ „
side and the outside of the visor.
.
4
clean
8
Safety instructions / Initial use
Adjust the welding helmet with the help
„ „
of the headband
dial headband 6
welding helmet to the respective head
size and the lateral control dial head-
7
band in order to lock the welding
helmet. When adjusting, ensure that your
head is placed as far into the helmet as
possible and that it sits as close as
possible to your face.
Set the appropriate darkening shade
„ „
before the welding procedure (see the
following table). The darkening shade
may be manually adjusted from 9 to 13
by twisting the darkening regulator
the outside of the helmet.
ATTENTION! The darkening regulator
has the setting position "grind". If the
9
darkening regulator
the automatic darkening is deactivated.
Only use this setting when you do not wish
to use the welding helmet for welding.
The automatic darkening is then no longer
active.
Check the light density before each use.
„ „
5
. Turn the rear control
in order to adjust the
9
is set to this position
9
GB/MT 59
on