Technical Data; Before Starting The Equipment; General Information - Parkside PKS 1700 A1 Bedienungs- Und Sicherheitshinweise

Anleitung_LB7_4300682:_
GB/
CY

6. Technical data

AC motor:
Power:
Operating mode:
Idle speed n :
0
Carbide saw blade: ø 210 x ø 30 x 2.8 mm
Number of teeth:
Swiveling range:
Miter cut:
Saw width at 90°:
Saw width at 45°:
Saw width at 2 x 45°
(double miter cut):
Protection class:
Weight:
Laser class:
Wavelength of laser:
Laser output:
Laser module power supply:
Noise emission values
The saw's noise is measured in accordance
with EN 61029.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
Total vibration values (vector sum of three
directions) determined in accordance with EN
61029.
Vibration emission value a
K uncertainty = 1.5 m/s 2
16
20.12.2010 9:32 Uhr Seite 16
Warning!
The specified vibration value was established in
accordance with a standardized testing
230V ~ 50Hz
method. It may change according to how the
1700 W
electric equipment is used and may exceed the
specified value in exceptional circumstances.
S1
4,800 min -1
The specified vibration value can be used to
compare the equipment with other electric
power tools.
24
-45° / 0°/ +45°
The specified vibration value can be used for
0° to 45° to the left
initial assessment of a harmful effect.
205 x 65 mm
Reduce noise generation and vibration to a
140 x 65 mm
minimum!
140 x 40 mm
II /
approx. 15 kg
2
650 nm
≤ 1mW
2 x 1.5 V Micro (AAA)

7. Before starting the equipment

7.1 General information

Idle speed
86 dB
3 dB
99 dB
3 dB
< 2.5 m/s 2
h
Use only equipment that is in perfect
condition.
Maintain and clean the equipment regularly.
Adopt your way of working to the
equipment.
Do not overload the equipment.
Have the equipment checked if necessary.
Switch off the equipment when not in use.
The equipment must be set up where it can
stand securely, i.e. it should be bolted to a
workbench, a universal base frame or
similar.
All covers and safety devices have to be
properly fitted before the equipment is
switched on.
It must be possible for the blade to run
freely.
When working with wood that has been
processed before, watch out for foreign
bodies such as nails or screws, etc.
Before you press the ON/OFF switch check
that the saw blade is fitted correctly. Moving
parts must run smoothly.
Before you connect the equipment to the
power supply make sure the data on the
rating plate are identical to the mains data.