Parkside PKS 1700 A1 Bedienungs- Und Sicherheitshinweise Seite 13

Anleitung_LB7_4300682:_
Do not exceed the maximum speed
specified on the blade.
Be sure to only use spacers and spindle
rings specified by the manufacturer as
suitable for the intended purpose.
If the machine is equipped with a laser, this
laser may not be replaced by a different
type of laser. Repairs may only be carried
out by the manufacturer of the laser or one
of his authorized agents.
Do not remove any cutting residues or other
parts of workpieces from the cutting zone
while the machine is running and the saw
unit is not at rest.
Make sure that the machine is always
secured on a workbench or a table if at all
possible.
Support long workpieces (e.g. with a roller
table) to prevent them sagging at the end of
a cut.
6. Additional safety information on
crosscut saws
Give these safety instructions to all persons
who work on the machine.
Do not use this saw to cut fire wood.
Caution! Hands and fingers may be injured
on the rotating saw blade.
Before you use the machine for the first
time, check that the voltage marked on the
rating plate is the same as your mains
voltage.
If you need to use an extension cable, make
sure its conductor cross-section is big
enough for the saw's power consumption.
Minimum cross-section: 1.5 mm
If you use a cable reel, the complete cable
must be pulled off the reel.
Operators have to be at least 18 years of
age. Trainees of at least 16 years of age are
allowed to use the machine under
supervision.
Persons working on the machine should not
be distracted.
Note the direction of rotation of the motor
and saw blade.
After you have switched off the motor, never
slow down the saw blade by applying
pressure to its side.
Only fit blades which are well sharpened
20.12.2010 9:32 Uhr Seite 13
and have no cracks or deformations.
Faulty saw blades must be replaced
immediately.
Never use saw blades which do not comply
with the data specified in this manual.
It is imperative to make sure that the arrow
on the saw blade conforms with the arrow
on the machine.
Pull out the power plug and twist the blade
with your hand into the 45° and 90°
positions in order to make sure that the
blade does not touch the turntable in any
position. If necessary, readjust the saw
head.
It is imperative to make sure that all devices
which cover the saw blade are in good
working order.
Never wedge the hinged saw blade guard in
open position.
Never dismantle the machine's safety
devices or render them inoperative.
Damaged or faulty safety devices have to
be replaced immediately.
Never cut workpieces which are too small to
hold securely in your hand.
Avoid placing your hands in hazardous
positions in which, one or both hands could
touch the saw blade if they slip suddenly.
The saw must not to be used for cutting
round workpieces.
There must be no nails or other foreign
bodies in the part of the workpiece that you
wish to saw.
Always stand to the side of the saw blade
when working with the saw.
2 . Never load the machine so much that it cuts
out.
Always press the workpiece firmly against
the workbench and the stop rail to prevent
the workpiece wobbling or twisting.
Ensure that the off-cuts can be removed to
the side of the saw blade. Otherwise it is
possible that they will be caught by the saw
blade and catapulted out of the machine.
Never saw more than one workpiece at any
one time.
Never remove loose splinters, chips or
jammed pieces of wood when the saw
blade is running.
To rectify faults or remove jammed pieces
GB/
CY
13