Technical Data - Parkside PZKS 1500 B2 Bedienungs- Und Sicherheits Hinweise, Originalbetriebsanleitung

Technical data

• The laser outlet opening is located at the
front of the laser's visible end; see Fig.
21 No. (13).
• Do not look directly into the laser beam
with unprotected eyes.
• Never look into the path of the beam.
• Never point the laser beam towards
reflecting surfaces and persons or
animals. Even a laser beam with a low
output can cause damage to the eyes.
• Caution- methods other than those
specified here can result in dangerous
radiation exposure.
• Never open the laser module. unexpected
exposure to the beam can occur.
• The laser may not be replaced with a
different type of laser.
• Repairs of the laser may only be carried
out by the laser manufacturer or an
authorised representative.
6. Technical data
Rated voltage 220 - 240 V ~ 50Hz
Power 1200 W
Operating mode S6 25% 1500 W
Idle speed n 5000 min
0
Carbide saw blade Ø210 mm x 2,6 mm x Ø30 mm
Number of teeth 24
Mitre sawing range 0°- 45° (to left and right)
Bevel sawing range 0°- 45° to the left
Maximum cutting capability：
Mitre/Bevel Angle
Horizontal Vertical
0° 0°
45° 0°
0° 45°
45° 45°
Protection class II/
Weight approx.13 kg
Laser class 2
Wavelength of laser 650 nm
Laser output ≤1 mW
* S6, continuous operation periodic duty.
Identical duty cycles with a period at
load followed by a period at no load.
-1
Maximum cross-section
(length and depth) of the
cut / the workpiece (mm)
340 x 58 mm
240 x 58 mm
340 x 32 mm
240 x 32 mm
Running time 2 minutes; duty cycle is
25% of the running time.
Minimum workpiece sizes (all workpieces
that can be clamped from the saw blade
with the supplied material clamp): 140 x
50 mm (length x width). Cutting depth,
max. (0°/0°): 58 mm
Make sure that the workpiece is always
secured with the clamping device.
Noise
Total noise values determined in accordance
with EN 61029.
sound pressure level L
pA
uncertainty K
pA
sound power level L
WA
uncertainty K
WA
Wear hearing protection.
The effects of noise can cause a loss of
hearing.
Vibration levels
Total vibration value at the handle
≤ 2.5 m/s²
Measurement uncertainty: 1.5 m/s²
The measurements were performed in
accordance with EN 61029-1 and
EN 61029-2-9.
The specified vibration emission level was
measured on the basis of a standardised
test procedure and can be used to compare
power tools with one another.
The specified vibration emission level may
also be used to initially assess the
exposure.
Attention!
While actually using the power tool, the
vibration emission level may differ from the
level specified depending on how the power
tool is used.
98.8 dB(A)
3 dB(A)
111.8 dB(A)
3 dB(A)
GB / IE / NI 9