Silvercrest SUR 46 A1 Bedienungs- Und Sicherheitshinweise Seite 80

Operation
Then fill the stainless steel tank
The liquid must cover the object that is to be cleaned, but must not
exceed the mark indicating the maximum filling height.
If the stainless steel tank
device immediately until dry.
Important! Never use the ultrasonic cleaning device without
water as the device may be damaged!
1. Close the cover
The figure
standard – this is the standard time for a normal degree of soiling.
2. Select the desired time from five possible intervals:
(
the desired time according to the degree of soiling.
3. Press the On-switch
The blue indicator light
in the display
Note: During the cleaning process a quiet vibration noise can be
heard; this is caused by the cleaning process.
4. After the set time has elapsed the cleaning process is automatically
stopped, the blue indicator lamp
shows . The originally selected time interval in minutes / symbol
remains visible.
5. Press the Off-switch
if necessary. The time remaining from the selected time interval is
shown on the display
the cleaning process
timer button
Important! You can repeat the cleaning process in order to
intensify the cleaning effect.
80 GB/MT
overflows, wipe off the outside of the
7
and insert the mains plug
5
(180 seconds) appears in the display
and start the cleaning process.
1
on the lid
6
counts down to 0.
2
to stop the cleaning process prematurely
3
. Press the On-switch
2
. Or select a new time interval using the
1
and press the On-switch
4
with normal tap water.
7
12
). Use the timer button
illuminates while the time
5
goes off and the display
6
1
again.
1
.
as
2
to set
4
2
again to resume