Herunterladen Inhalt Inhalt Diese Seite drucken

Operation; Wall Mounting; Cleaning - Silvercrest SSMS 600 A1 Bedienungsanleitung

Stabmixer-set
Vorschau ausblenden Andere Handbücher für SSMS 600 A1:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 27
³ Fill the bowl with the foodstuffs you wish to liquidise.
³ Place the lid 5 on the bowl and turn it until it is
secure. Ensure that the lugs on the edge of the
bowl are guided into the recess on the lid.
³ Place the motor unit 3 on the lid 5 so that the
arrow points to the symbol
unit 3 until the arrow points to the symbol
Note: Should you wish to keep liquids/foods in
the chopper, you can remove the base of the
measuring beaker and use it as a lid. For this,
carefully remove the lid 5 and motor block 3
and, if needs be, the blade 6. Loosen the bot-
tom of the chopper and put it on the chopper.

Operation

Warning:
Foodstuffs should not be too hot. Contents squirted
out may cause scalding.
Risk of fire:
Never exceed the maximum operating duration
of 1 minute. Allow the appliance to cool down for
2 minutes before switching it on again.
Note: When you beat cream with the whisk 9,
hold the container at a slant during the bea-
ting. In this way the cream will be thicker quik-
ker. Ensure that cream cannot be sprayed out
of the container while it is being beaten.
When you have assembled the hand blender for
your particular purpose, insert...
³ The plug into the mains power socket.
³ Hold down the switch 1 to process the foodstuffs
at the standard speed.
³ Hold down the turbo-switch 2 to process the
foodstuffs at the higher speed.
³ When you have completed processing the food-
stuffs, simply release the switch.
. Turn the motor
.
- 22 -

Wall mounting

Included are 2 dowels and 2 screws to enable the
wall bracket q to be installed.
³ Mark the positions of the drill holes using the
wall bracket q.
³ Bore the holes with a 6 mm drill.
³ Insert the dowels into the drill holes.
³ Position the openings of the wall-holder q over
the drill holes and then secure it using both of
the screws.

Cleaning

Risk of electric shock!
Before you clean the hand blender, unplug the
appliance from the power socket. Under no circum-
stances may the motor unit 3 be cleaned by
immersing it in water or holding it under running
water.
Risk of personal injury!
To prevent injuries, exercise caution when handling
the extremely sharp blade 6. Reassemble the liquidiser
after use and cleaning to prevent injury from the
exposed knife blade. Keep the blade out of the reach
of children.
Attention!
Do not clean the attachments of your hand blender
in the dishwasher as it may cause damage to them.
³ Unplug the power cable from the wall socket.
³ Clean the motor unit 3, the hand blender 4,
the lid 5 and the whisk-holder 8 with a moist
cloth.
Ensure that water cannot permeate through the
openings of the hand mixer 4. For stubborn
soiling use a mild detergent on the cloth.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis