To Assemble The Hand Blender; Assembling The Wire Whisk; Operation - Silvercrest SSMS 600 E5 Bedienungsanleitung

To assemble the hand blender

WARNING! RISK OF INJURY!
► The blade is extremely sharp! Handle it with great care at all times.
Place the hand blender 5 on the motor unit 4 so that the arrow points to
■
the symbol
points to the symbol

Assembling the wire whisk

Press the whisk 7 into the whisk holder 6, until it firmly engages.
■
Place the so assembled whisk 7 onto the motor block 4 so that the arrow
■
points to the symbol
symbol

Operation

WARNING! RISK OF INJURY!
► Foodstuffs should not be too hot. Squirting contents may cause scalding.
NOTICE
When you beat cream with the whisk 7 hold the container at a slant during
►
the beating. In this way the cream will be thicker quicker. Ensure that cream
cannot be sprayed out of the container while it is being beaten. When
whipping cream, slide the speed regulator 1 to position "Max".
When you have assembled the blender set as you wish to use it:
1) Insert the plug into a mains power socket.
2) Press and hold the switch
Slide the speed regulator 1 in the direction of "Max" to increase the speed.
Slide the speed regulator 1 in the direction of "Min" to reduce the speed.
3) Press and hold the turbo-switch 3 to process foodstuffs at a higher speed.
By pressing the turbo-switch 3 the maximum processing speed is available
immediately.
4) Once you are done processing the food, simply release the pressed switch
│ GB │ IE
■ 8
. Turn the hand blender 5 until the arrow on the motor unit 4
.
Turn the motor block 4 until the arrow points at the
.
2/3.
2 to process foodstuffs at the standard speed.
SSMS 600 E5