Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
02. Press and hold key ■ again (for approx. 5 sec-
(5")
onds), until the motor performs 4 SHORT moti -
4
ons; then release the key.
03. Press and hold keys ▼ and ▲ simultaneously (for
approx. 5 seconds), until the motor completes 5
5
LONG motions (= position "H" deleted); then re -
lease the keys.
8.2 - Moving the position of limit switch "1"
01. Press and hold key ■ (for approx. 5 seconds), until
(5")
the motor performs 1 VIBRATION; then release
1
the key.
02. Press and hold keys ■ and ▼ simultaneously (for
(5")
approx. 5 seconds), until the motor starts to move
1
the shutter automatically, moving it to position 1,
and then release the keys.
03. (within the next 4 seconds) Use keys ▼ and ▲ to
position the shutter in the new position "1" required.
1
04. (within the next 4 seconds) Press and hold keys ■
and ▼ simultaneously, until the motor completes 2
2
LONG motions (= new position "1" memorised);
then release the keys.
8.3 - Deleting the positions of limit switches "0" and "1"
01. Press and hold key ■ (for approx. 5 seconds), until
(5")
the motor performs 1 VIBRATION; then release
1
the key.
02. Press and hold key ■ again (for approx. 5 sec-
(5")
onds), until the motor performs 4 SHORT moti -
4
ons; then release the key.
12 – English
03. Press and hold key ▲ for approx. 5 seconds (if the
(5")
limit switches have been programmed with the
5
Automatic or Manual procedure), or key ▼ (if the
limit switches have been programmed with the
Semiautomatic procedure), until the motor com-
pletes 5 LONG motions (= positions "0" and "1"
deleted); then release the key.
Note – After deleting positions "0" and "1", the shutter can only be moved in "hold-
to-run" mode, i.e. keeping the key of a transmitter or wall-mounted pushbutton for
the time required.
8.4 - Deleting transmitters from the For-Max memory
Caution! – This function deletes all transmitters stored in the For-Max memo-
ry. The procedure can be performed with a memorised transmitter or one that
is not.
With a transmitter already memorised:
01. Press and hold the key ■ (for approx. 5 seconds),
(5")
until the motor performs 1 VIBRATION; then re -
1
lease the key.
02. Press and hold the key ▲ until the motor performs
3 LONG motions; then release the key precisely
3
on the third motion.
03. Press and hold the key ■ until the motor performs
3 LONG motions; then release the key precisely
3
on the third motion.
04. Press and hold the key ▼ until the motor performs
3 LONG motions; then release the key precisely
3
on the third motion.
After a few seconds the motor completes 5 LONG
motions (= all transmitters deleted).
5
Werbung
Inhaltsverzeichnis
