Function Programming - Nice For-Max A Anweisungen Und Hinweise Für Die Installation Und Die Bedienung

– Never interrupt these two manoeuvres or disconnect power supply dur-
ing these movements.
7.7 - Programming limit positions "0" and "1" SEMI-AUTOMATICALLY
Caution! – This programming mode is recommended for shutters that mount
"plugs" only.
Programming position "0" followed by position "1".
To program limit position "0":
01. Press and hold the pushbutton (Up or Down) to move the shutter to the point of
mid-travel. Note – during movement, 2 brief interruptions indicate that no limit
position is memorised.
02. Press and hold the pushbutton (Up or Down) until the shutter stops on impact
with limit switch "0" then release the pushbutton.
To program limit position "1":
01. Press and hold the pushbutton (Up or Down) to move the shutter to the point of
mid-travel. Note – during movement, 1 brief interruption indicates that only one
limit position is memorised.
02. Press and hold the pushbutton (Up or Down) until the shutter moves to the
required limit position "1", then release the pushbutton.
03. Press and hold the two Up and Down pushbuttons simultaneously (for at least
3 seconds), until the motor has completed a short movement in the opposite
direction.
04. At this point, activate an Up manoeuvre followed immediately by a Down ma -
noeuvre to enable the control unit to memorise the two limit positions. Caution!
– Never interrupt these two manoeuvres or disconnect power supply dur-
ing these movements.
8

FUNCTION PROGRAMMING

Warnings:
- These functions can only be programmed if limit positions "0" and "1" are already
programmed.
- Unless otherwise specified, these functions are programmed exclusively by
means of a transmitter.
- Use exclusively a transmitter memorised in "MODE I" (see paragraphs 6.4 - 6.5).
8.1 - Intermediate position "H" (= partial open/close)
Position "H" is an intermediate point along the shutter travel line in which the latter
remains partially open/closed.
When position "H" is programmed, the shutter can be brought to this position by
pressing keys ▲ and ▼ simultaneously on the transmitter or wall-mounted panel, for
Up and Down.
Memorisation procedure:
01. Using the transmitter keys, move the shutter to the
H intermediate position to be memorised.
02. Press and hold key ■ (for approx. 5 seconds), until
(5")
the motor performs 1 VIBRATION; then release
1
the key.
03. Press and hold key ■ again (for approx. 5 sec-
(5")
onds), until the motor performs 4 SHORT moti -
4
ons; then release the key.
04. Press and hold keys ▲ and ▼ simultaneously, until
the motor completes 3 LONG motions (= position
3
"H" memorised); then release the keys.
Deletion procedure:
01. Press and hold key ■ (for approx. 5 seconds), until
(5")
the motor performs 1 VIBRATION; then release
1
the key.
English – 11