Electrical Characteristics; Safety Devices - EdilKamin PELLET-BLOK Handbuch

THERMOTECHNICAL CHARACTERISTICS
Nominal power
Efficiency nominal power
Emissions CO (13% O2) nominal power
Smoke mass nominal power
Reduced power
Efficiency reduced power
Emissions CO (13% O2) reduced power
Smoke mass reduced power
Maximum overheated smoke
Minimum draught
Autonomy (min/max)
Fuel consumption (min/max)
Hopper capacity
*
Heatable volume
Weight including packaging
Smoke outlet pipe diameter (male)
Air intake pipe diameter (male)
*
The heatable room dimensions are calculated on the basis of pellets with an lhv of at least 4300 kcal/kg and home insulation in
compliance with Italian law 10/91, and subsequent changes together with an expected heat output of 33 Kcal/m³ per hour.
*
It is also important to consider the position of the fireplace in the room to be heated.
The data shown above is purely indicative. EDILKAMIN s.p.a. reserves the right to make changes to these pro-
ducts to improve their performance with no prior warning.

ELECTRICAL CHARACTERISTICS

Power supply
Average power consumption
Power consumption during ignition
Remote control frequency
Protection on mains power supply
Protection on electronic circuit board

SAFETY DEVICES

THERMOCOUPLE:
placed at the smoke outlet to detect the temperature. Turns the stove on and off and controls its operation based on defined
parameters.
SAFETY THERMOSTAT:
Intervenes when the temperature within the fireplace is too high.
Blocks pellet loading causing the fireplace to turn off.
ROOM TEMP. DETECTION PROBE:
An outlet for the 1 metre room temperature cable is provided near one of the two fans.
The sensor, which will be attached to the wall using the bracket provided, is wired onto the end of the cable.
FEATURES
25
15
93,9
0,015
7,9
4,7
95,9
0,029
4,4
125
12
10,5/35
1/3,3
38
390
231
80
80
230Vac +/- 10% 50 Hz
100 W
400 W
Radio waves 2.4 GHz
2AT, 250 Vac, 5x20 Fuse
2AT, 250 Vac, 5x20 Fuse
kW
%
ppm
g/s
kW
%
ppm
g/s
°C
Pa
hours
kg/h
kg
m 3
kg
mm
mm