36 7.2 Hydraulic Connection; Of High-Pressure Pump; 37 7.3 Connecting Pressure Sensor - Bosch CRS 845H Instandsetzungsanleitung

en 62 | CRS 845H | Calibrating high-pressure rail
7.2 Hydraulic connection

of high-pressure pump

i
The high-pressure hose 1 680 712 324 for connect-
ing the high-pressure pump to the high-pressure rail
is included in the scope of delivery of the test set
CRS 845H.
!
Heed the tightening torque.
25 - 30 Nm
1
Fig. 35: Hydraulic connection
1. Connect the inlet hose (Pos. 1) and the return hose
(Pos. 2).
2. Connect the high-pressure hose (Pos. 3) to the high-
pressure pump and the high-pressure rail.
|
1 689 975 229 2011-09-16
2
3
7.3 Connecting pressure sensor
i
The first time the pressure sensor is used, the oper-
ating system twice prompts the user to install a driv-
er. Select "Search for appropriate driver for device
(recommended)" and then "State other source". The
driver is stored under 'C:\BOSCH_PR\EPS945\DRIV-
ERS\BURSTER' (up to EP-Software version 2011/A),
or in 'C:\BOSCH_PR\EPS945\DRIVERS\BURSTER\
X86' (from EP-Software version 2011/A).
1. Connect the pressure sensor to the CRI 846 distribu-
tor rail connection of the high-pressure rail.
Tightening torque: 25 - 30 Nm
2. Connect the USB cable to a vacant USB connection
of the KMA-PC.
1
X2 Mouse
X25 USB1
1
X1 Kayboard
0
X26 USB2
Fig. 36: Pressure sensor connection
1 KMA-PC
2 USB cable
3 Converter
4 Pressure sensor
X28
S
X27
V
X9 C
A T
V
W
BOSCH N
1
I
D
X29
E S
O V
T
X7 LPT1 W
2
X3 COM1 X4 COM2
2
3
4
458845-08_Pal
Robert Bosch GmbH