Conversion And Extension; Troubleshooting; Technical Data - Aventics AS1 Betriebsanleitung

AVENTICS | AS1 / AS2 / AS3 / AS5 | R412013433–BAL–001–AG | English
8 Disposal
Dispose of the product and condensate in accordance with the national regulations
in your country.
9

Conversion and Extension

Danger of injury in case of disassembly or replacement under pressure
or voltage
Disassembling or replacement when under pressure or electrical voltage
may lead to injuries and damage to the product or system components.
O Make sure that the relevant system part is not under voltage or pressure
before you disassemble the product or replace parts.
O Protect the system against being switched on.
Danger of burns!
The surfaces of adjacent system components can become hot during operation.
O Let the system component cool off before disassembling it.
13
Changing flow direction
No conversion is necessary on the AS1 series. The "right/left flow" version
has a separate order number.
On delivery the flow direction is from left (1, IN) to right (2, OUT). The following
conversion on the product is necessary if the flow direction is to be changed:
Regular conversion (13-I)
On practically all components, the flow direction change is performed by rotating
mounting by 180° around the vertical axis. The housing covers need to be changed
for the purpose.
1. Remove the housing cover on the front and rear and replace at the opposite side
(the order number can now be read off at the front).
2. Mount components at position 180° around the vertical axis.
Conversion for AS2 shut-off valves and filling valves in all series (13-II)
As the exhaust is at the rear on these components, the housing cover cannot
be changed over.
Install the components rotated 180° around the lateral axis to change the flow
direction.

10 Troubleshooting

Malfunction Possible cause
Pressure/flow Operating pressure
level is not too low
reached or drops
Leak on tubing
off slowly.

11 Technical Data

Maximum permissible pressure, temperature range, and thread connection
are indicated on the products.
General data
Mounting orientation Any
Medium/ambient -10 °C /+50 °C
temperature min./max.
Further technical data can be found in our online catalog at
www.aventics.com/pneumatics-catalog.
CAUTION
Remedy
W
Set higher operating pressure
W
Check tubing diameter
Check tubing and tubing
connections
9