Adjusting Of The Pushing Handles - Vermeiren Eclips+ AD Gebrauchsanweisung

A
3.9

Adjusting of the pushing handles

"
!
WARNING:
Risk of injury - Make sure that all screws are properly tightened with
the appropriate tool.
"
!
WARNING:
Risk of tipping over - Make sure that the tubes of the pushing
handles are positioned identically on both sides.
3.9.1 Pushing handles
The tube handle " is fixed to the back frame !.
Adjust the height of the pushing handles as follow:
1. Remove the arm supports.
2. Remove the screws #.
3. Remove the screws $ for suspending the
armrests.
4. Pull the tube handle to the desired height.
Pusing handle height Tube handles "
910 mm (35.83 in.)
(Standard)
925 mm (36.42 in.)
940 mm (37.00 in.)
955 mm (37.60 in.)
970 mm (38.19 in.)
985 mm (38.78 in.)
1000 mm (39.37 in.)
1015 mm (39.96 in.)
Table 4: Pushing handle heights
5. Retighten all the fixing screws #!$"properly.
!"#$%'&%
Eclips+ AD
Tube frame !
Hole 9 and 11 Hole 1 and 2
Hole 8 and 10 Hole 1 and 2
Hole 7 and 9 Hole 1 and 2
Hole 6 and 8 Hole 1 and 2
Hole 5 and 7 Hole 1 and 2
Hole 4 and 6 Hole 1 and 2
Hole 3 and 5 Hole 1 and 2
Hole 2 and 4 Hole 1 and 2
EN
2011-03
B
1