Anatomical Backrest; Adjust The Brakes; Adjusting Of The Foot Rests - Vermeiren Eclips X4 KIDS Gebrauchsanweisung

3.8

Anatomical backrest

L WARNING:
Risk of injury – Check that the backrest is secured before use.
L WARNING:
Risk of injury – Avoid getting your fingers caught during the
assembly process.
3.9

Adjust the brakes

L WARNING:
Risk of injury – Brakes may only be adjusted by your specialist
dealer.
Adjust the brakes according following rules:

3.10 Adjusting of the foot rests

3.10.1 Length of the foot rests
L CAUTION:
Risk of damage – Avoid that the foot rests make any contact with the
ground. Keep a minimum distance from 60 mm above the ground.
Adjust the length of the foot rests as follow (2 positions possible: steps 35 mm → holes
outside tube, 4 positions possible: steps 25 mm → inner tube)
1. Remove the screw
2. Adjust the length of the foot rest to a comfortable length.
3. Tighten the screw
To use the anatomical backrest, proceed as follows:
1. Unscrew the flexible backrest.
2. Loosely screw on the brackets for the backrest.
3. Insert the backrest into the brackets from above.
4. Tighten the screws holding the brackets for the
backrest.
5. Insert and tighten the safety screws for the
backrest.
1. Install the wheels according § 2.2.
2. Disconnect the brakes by pulling lever
backwards.
3. Loosen the bolts
mechanism can slide over the guide
4. Pull the brake mechanism over the guide
the desired position.
5. Retighten the bolts .
6. Check working of the brakes.
7. If necessary repeat the above steps until the
brakes are adjusted well.

.

properly.
Page 19
Eclips X4 kids


so the brake

.
(Fig A):
2016-01

to