Back - Vermeiren Eclips+ AD Gebrauchsanweisung

Changing the seat cover as follows:
1. Remove the screw at the front end of the seat frame.
2. Pull the locking pin #out.
3. Now the seat " can be removed by pulling it gently forwards out the groove of tube !.
Do the reverse when you want to replace the seat.
3.6

Back

"
!
WARNING:
Risk of injury - Make sure that all screws are properly tightened
before using the wheelchair.
"
!
Risk of injury ! Ensure that all the securing straps are sufficiently
WARNING:
tightened and do not hang through.
1
C
C
B
The height of the back can be adjusted by setting the
entire back tube.
For adjusting the height of the back cover, loosen the
fixing screws ! behind the back tube. Then you can
move the cover upwards or downwards. There are fixing
holes every 20 mm (0.79 in.) in the back tube where the
screws can be retightened.
The back can be used for a seat width of 390 mm to 500
mm. Loosen the Velcro fastening on all 5 straps (a) and
pull the straps to the length you require by pulling them
A
through the flaps (B).
When you have adjusted the straps to the required length,
fasten them back up. The rear cushion can now be
attached to the front of the cover by fastening the straps
on the rar cushion to the side-straps (C) on the adjustable
seat.
The rear flap is drawn over the top end of the rear cover
and can be fastened backwards to the cover.
!"#$%&.%
EN
Eclips+ AD
2011-03