Finishing Work - ATIKA ASP 5,5 Bedienungsanleitung

2. Fasten the table in the top position.
3. Switch on the device and continue the splitting
operation.
Never try to split two logs at once.
Never try to remove or replace the log during the splitting
process.
Never try to force the splitting of the log by maintaining
the pressure for several seconds. This can lead to damage to
the machine.
Position the log on the table again and repeat the splitting
phase, or put the log on one side.
How to release a jammed log?
There is a risk of knotted logs getting stuck during the
splitting process.
1. Switch machine off and disconnect the power.
2. Carefully move the stuck log backwards and forwards to
loosen it.
Never hammer on the stuck log.
Never use a saw to cut the stuck log out of the machine.
Do not enlist the aid of a second person - this is a one-
man job.

Finishing work:

Bring the splitting blade to the lower position (run-in
state).
Release one of the control handles.
Switch the machine off and disconnect the power.
Follow the care and maintenance instructions.
C a r e a n d
C a r e a n d
Remove the plug from the power socket before
starting any maintenance or cleaning work.
Wear protective gloves in order to avoid injury to the
hands.
Observe the following in order to keep the log splitter in
good working order:
Clean the machine thoroughly after you have
finished using it.
Remove any resin remains on the machine.
Lubricate the splitting column regularly or oil it using
environmentally friendly spray oil.
Check the oil level and change the oil as necessary.
Check hydraulic hoses and hose connections
regularly for any leaks and firm fitting.
m a i n t e n a n c e
m a i n t e n a n c e
Sharpening the splitting blade
After longer operating periods, for reduced splitting
performance or slight deformation of the cutting edge, grind
the splitting blade or sharpen it with a fine file (remove burrs).
16
Sharpen wedges
How do I check the oil level?
1. The splitting
column must be in
run-in state.
2. Now remove the
dipstick.
3. Clean the dipstick
and the oil seal.
4. Replace the
dipstick fully into
the oil reservoir.
5. Now remove the
dipstick again,
and read off the
oil level.
Oil dip stick
18
If the oil level is between the two marking on the
dipstick, there is sufficient oil in the reservoir.
If the oil level is below the lower marking, more oil
should be added with the aid of a clean funnel.
6. Check the oil
seal and replace
it if it is dama-
ged in any way.
7. Replace the
dipstick into the
oil reservoir.
20
17
upper marking lower marking
19