Aux In Mode - Silvercrest SBLP 4.2 A1 Bedienungsanleitung Und Sicherheitshinweise

SilverCrest SBLP 4.2 A1
* An acoustic signal is played when the minimum or maximum volume is
reached.
1
You will hear a confirmation tone in the speaker. Subsequently the
®
Bluetooth connection has to be re-established.

8.4 AUX IN mode

In AUX IN mode you have to connect the speaker to your audio source with
a cable. Proceed as follows:
 Turn your audio source down to a low volume.
 Open the cover to the AUX IN port (9).
 Connect the supplied audio cable (C) to the AUX IN port (9) and your
audio source.
 Hold down the on/off button (1) briefly to switch the speaker on. You will
then hear an acoustic signal that gradually increases in volume and the
operating LED (7) will flash blue.
 Briefly press the M button (2) to switch to AUX IN mode. The operating
LED (7) now lights up blue.
 Adjust the volume on your audio source or using the - button (4) and
+button (5).
 You can switch off the speaker by holding down the on/off button (1) for
approximately two seconds. You will hear an acoustic signal that
gradually decreases in volume.
48 - English