Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Dual Time-Temperature Mode
Certain foods benefit from dehydration at two different temperatures. Foods with high
water content (such as apples) will be much cooler than the surrounding air until they
lose much of their moisture. This is because evaporation cools the food even as it is
heated by the warm air. This effect can be as much as 36-45ºF / 20-25ºC. Dehydration
can be optimized by increasing the set temperature for an initial period and then
lowering it for the final drying. This speeds the drying process without overheating
the food. The Sahara Dehydrator automates this process with dual time-temperature
setting.
TIME / TEMP: This is the time and temperature associated with default operation. The
dehydrator will operate at this chosen temperature for the selected amount of time
unless manually shut off.
TIME2 / TEMP2: (Off by default). Access TIME2 / TEMP2 by pressing and holding the
Mode
button for two seconds. TIME2 / TEMP2 will appear on screen. Spin the
Control Wheel to select the desired time for TIME2. Then press the Mode Button
to
move the pointer arrow to TEMP2 and select the desired temperature. You can hold
the MODE button again for two seconds to switch back to TIME / TEMP.
TIME
TEMP
TIME2
TEMP2
6:00 150
10:00 135
°F
°F
Press Start
to begin operation. TIME2 / TEMP2 automatically starts when
TIME / TEMP is complete. Either TIME / TEMP or TIME2 / TEMP2 may be displayed
when pressing Start. The dehydrator will always begin operation with the first setting
TIME / TEMP. If TIME2 is set to zero, the process will end when TIME is complete.
The graph below represents an example dual temperature drying process.
Higher Temp
Setting
Lower Temp Setting
Time 1
Time 2
TIME2
TIME
brodandtaylor.com | 9
Werbung
Inhaltsverzeichnis
