WimTec MULTI 2 Montage- Und Bedienungsanleitung Seite 14

EN
MULTI 2
Congratulations on purchasing the WimTec
MULTI 2 urinal flush control.
Please take note of the following cleaning and
maintenance recommendations in order
to ensure that you will be able to enjoy this
high-quality fitting for many years:
Use mild cleaning agents
containing soap
Do not use abrasive, scrubbing or
acidic cleaning agents or disinfectants
or those with a nano protective
coating
Clean the fitting with a soft sponge
or cloth only
Do not use steam cleaners
This manual is valid for the following
products:
WimTec MULTI 2
Matt chrome, Art. no.
Glossy chrome, Art. no.
White, Art. no.
WimTec MULTI 2 - 230 V delivery scope:
Front plate with integrated electronics, integrated
safety transformer, magnetic valve, mounting
frame and mounting material.
WimTec MULTI 2 - 9 V delivery scope:
Front plate with integrated electronics, battery
module incl. 9 V battery, magnetic valve, mount-
ing frame and mounting material.
14 Urinal flush control
230 V 9 V
121 568 121 599
121 582 121 612
121 575 121 605
WimTec MULTI 2
Important installation notes:
Mounting and installation may only be performed
by a qualified service provider in accordance with
DIN 1988, ÖVE/ÖNORM E 8001 and
VDE 0100 Part 701.
Wire the mains cable via a 2-pin main switch
with a contact spacing of at least 3 mm and
ensure the fuse employed blows at max. 6 A!
When planning and installing sanitary facilities,
all relevant local, national and international
standards and provisions must be observed.
!
The "General installation terms and
conditions" provided at www.wimtec.com
apply.