Assembling The Appliance - SOLIS FB-616C Typ 8453 Bedienungsanleitung

GB
66
B
C
D
E
F
Carrier
A
Drive shaft
AS SEMB LI NG THE AP PLI ANC E
▲ ▲
1. Make sure that the power plug is not connected to the power outlet.
2. Push the lever press arm up and away from the motor base until it is stationary
in the highest position.
3. Place the carrier over the drive shaft.
4. Place the juice collector over the carrier resp. the drive shaft on the motor base.
Make sure that the juice spout is placed in the half-round opening on the front
of the motor casing.
5. Now, place the pulp filter in the juice collector. The black bulge in the centre
of the filter must be placed over the nib of the juice collector so that both parts
congruently fit into each other (both parts lie opposite of the press arm).
6. Now, place the juicing cone on the carrier resp. the drive shaft.
7. To install the squeezing cone in the lever press arm, push the connection piece
of the squeezing cone into the opening in the bottom of the lever. The nib of
the connection piece points upwards, so that the connection piece snaps into
the opening in the press arm.
➞
8. Now make sure that the juice spout is folded out, meaning it is in the position
for pouring.
9. The appliance is ready for use as soon as you connect the power plug to a suit-
able power outlet.
GB
67