Description Of Lcd Display; Preparing The Food - SOLIS Digital Juicer 849 Gebrauchsanleitung

DESCRIPTION OF LCD DISPLAY

1. This machine has five speed settings.
2. When the juicer is first plugged in, it goes into standby mode.
The LCD display lights up and shows the following information (Fig. 1).
Fig. 1
3. When the rotating switch is turned, the motor begins to run. The information shown in Figs. 2-6
appears in the LCD display as the rotating switch is moved in turn to settings 1-5.
Fig. 2 Fig. 3
Fig. 5 Fig. 6
4. The motor will not start if the clamp has not been secured properly. A flashing «L» will then appear
on the LCD display, as shown in Fig. 7.
Fig. 7
28
Solis_Digital-Juicer_Betriebsanleitung.indd 28-29
5. If the motor temperature rises above 110° C, the motor will switch off automatically until
6. If the juicer has not been used for a period of more than five minutes, the LCD display switches
Before plugging in to the mains electricity supply
1. Check that your mains voltage supply matches the voltage shown on the base of the machine.
2. The juicer meets the requirements specified in Switzerland and the European Union.
Before using the machine for the first time
1. Remove all packaging.
2. Wash the various components: please see the section on «Cleaning the machine».
OPERATING INSTRUCTIONS
Fig. 4
Fig. 1

Preparing the food

1. Remove any pips and stones (from plums, peaches, cherries, etc.).
2. Remove any hard skin (from melons, pineapples, cucumbers, potatoes, etc.). Fruit and vegetables with
3. Citrus fruits: peel the fruit and remove the white pith, otherwise the juice will have a bitter taste.
4. Slice off the hard upper section of carrots (Fig. 3).
5. Cut carrots in half or quarter if they are too thick to reach the filter when you put them into
the temperature drops back below 100° C.
off automatically.
soft skins (e.g. apples, pears, carrots, radishes, cabbages, parsley, celery, spinach, grapes, strawberries,
etc.) just need to be washed.
the feed chute (Fig. 4).
Fig. 2
23.06.10 09:45
29