Safety Information; Functions; General Function; Driving Mode - Mini Advanced Car Eye 2.0 Bedienungsanleitung

Safety information

The ACE 2.0 may only be installed by a MINI
workshop.
The ACE 2.0 app must not be used by the driver
whilst the engine is running or whilst driving.
If you sell the device, ensure that you give
the buyer the operating manual and the
declaration of conformity sheet.
The ACE 2.0 must be reset to factory settings
using the ACE 2.0 app before it is passed on to
third parties.
Ensure that the micro SD card has been
formatted using the ACE 2.0 app before you
pass the device onto third parties.
The Wi-Fi settings can be reset to factory
settings using the button combination on the
front camera.
Press the Power key (1) on the rear and the
microphone ON/OFF key (2) on the side of
the front camera simultaneously for at least
3 seconds for this purpose.

Functions

General function

The ACE 2.0 consists of two full HD wide-
angle cameras, which can record accident
incidents whilst driving and property damage
during parking both in front or and behind
your car. It features proximity sensors at the
front and rear (radar sensors) and a vibration
sensor (G sensor) and can automatically record
media data in the form of photos and video
sequences. It is primarily controlled using the
ACE 2.0 app.
A defined logic system in the operating modes
described below enables the ACE 2.0 to
monitor your car.
Acoustic instructions and voice output keep you
up to date with the status of your ACE 2.0.
Not every recorded event means that
there is necessarily an incident involving
the car.

Driving mode

Driving mode is started automatically as soon
as the car's ignition is switched on. The car
can now be monitored using two different
recording modes. Depending on the situation,
using the vibration sensor (G sensor), in other
words, if there is a vibration above the set
threshold value (sensitivity), the ACE 2.0 will
record a 60-second video sequence. A signal
tone will sound from the ACE 2.0 speaker and
the safety LED on the front camera will flash
to indicate this recording. Using an internal
storage module, the recording of this video
sequence starts on the micro SD card 10
seconds before the G sensor is triggered so
that the events prior to the vibration are also
recorded.
Permanent recording can also be activated.
In this mode, 60-second video sequences are
recorded continuously and saved in sequence.
29