Eufab BIKE TWO Bedienungsanleitung Seite 7

Protective mould left
Rear light, left
Mount the license plate holder to the rack traverse and align it so that it is positioned centrally to the license plate illumination.
Seal the ends of the tubes on the rack traverse using the square plugs 30 x 20 [mm] and on the rack table with the square plugs 80 x 30 [mm].
Now push two wheel stoppers on the right and left from above onto the wheel rails. Make sure that the higher side of the wedge shape points towards the middle of the
rack. Insert the small tensioning strap through the middle opening of the stopper and under the wheel rail on the opposite side, then back through the middle opening.
The remaining two straps are used later to correctly secure the bicycles.
Open the cuffs of the frame holder by unscrewing the knob and place the cuffs around the tube of the U-shaped bracket with their inserts. Close the frame holder again,
but do not tighten.
4.2 MOUNTING THE BICYCLE RACK ON THE TRAILER TOW BAR
Make sure that the trailer tow bar is undamaged, clean and grease-free.
The bicycle rack is placed on the coupling from above. Tighten the M16 screw slightly and align the bicycle rack parallel to the rear of the vehicle. Now tighten the M16 screw
so that the rack is securely attached.
Regularly check the firm seating of the rack on the trailer tow bar as well as the functionality of the lighting systems.
4.3 MOUNTING THE BICYCLES TO THE CARRIER
The first bicycle is placed in the first bicycle rail (closest to the vehicle) and secured to the U-shaped bracket using the short frame holder.
The wheels are secured by pushing the stoppers up to the wheel and securing with the straps.
Caution: The front wheel must also be secured with a small tensioning strap to prevent it from turning.
The second bicycle is placed in the second rail, facing the opposite direction and secured to the U-shaped bracket with the long frame holder. The wheels are secured in the
same way as for the first bicycle. It may be necessary to arrange the individual bicycles differently on the rack to ensure that the frame holders may be correctly secured.
Now secure the bicycles with the long safety strap. Wrap the safety strap through the bicycle frames and the U-shaped bracket and tighten.
Washer 5 mm Nut M5
Rear driving light
6 x straps
4 x
Wheel Stoppers
Protective mould right
Rear light, right
7