Ottobock 50A10N Omo Immobil Gebrauchsanweisung Seite 14

straps, hand pad and abductor can be attached to the orthosis with hook
and loop patches.
The 50A11N Omo Immobil Rotation orthosis also features various ele-
ments for setting the external rotation to 10°, 20° or 30°. When required,
an element can be attached to the tube frame by undoing two locking pins.
2 Handling
2.1 Size Selection
The size of the orthosis is selected according to body height.
2.2 Adapting and Applying the Product
The initial fitting and application of the product must be carried out by
trained, qualified personnel only.
2.2.1 Adapting the product
Setting the body side
The shoulder joint orthosis comes already adjusted for the right arm. To set
it up for the left side, remove the waist belt and the hand pad and attach
them laterally reversed on the opposite side of the torso component (Fig.
2). When reattaching the waist belt, make sure that the strap guide loop
is at the front (anterior). Remove the arm straps and undo the shoulder
strap closure. Do not remove the shoulder pad from the shoulder strap.
Once adjusted for the left shoulder, turn the pad on the strap so that seam
is away from the body.
Setting the abduction angle
The desired abduction angle can be set with the abduction wedges that
attach to the orthosis with hook and loop patches. To do this, unfold the
orthosis and position the wedge at the upper pivot point of the joint (where
the torso support and arm rest connect) on the arm rest (Fig. 3). Fold back
the arm rest. If 0° abduction is desired, attach the double-sided hook strip
at the position described above.
Shortening the shoulder strap or waist belt
To produce the desired effect, the orthosis must always be
INFORMATION
firmly applied. Custom adjustment is an important prerequisite for suc-
cessful treatment.
If necessary, the waist belt and should strap can be shortened by an ortho-
tist. To do this, remove the hook and loop closure from the strap, shorten
14 | Ottobock