Installation - Klarstein 10032283 Handbuch

Control Panel - Variant 2
1 Heating zone selection controls
2 Timer control
3 Power / Timer / Keylock control

INSTALLATION

Cut out the work surface according to the sizes shown in the drawing. For the purpose
of installation and use, a minimum of 5 cm space shall be preserved around the hole.
Be sure the thickness of the work surface is at least 30mm. Please select heat-resistant
work surface material to avoid larger deformation caused by the heat radiation from the
hotplate. As shown below:
L (mm) W (mm)
590 520
4 Dual/Oval zone control
5 ON/OFF control
H (mm) D (mm) A (mm)
52 48
B (mm) X (mm)
560 490 50 min
EN
25