Fitting The Stand (Optional); Usage - FLORABEST FLG 40 A1 Bedienungsanleitung Und Sicherheitshinweise

7.2 Fitting the stand (optional)

If you do not wish to place the charcoal barbecue on the table, you can fit the stand (11). Proceed as
follows:
1. Fold out the three legs on the stand (11).
2. Loosen the knurled screw and remove it completely.
3. Push the central shaft up as far as it will go and lock it in place using the
knurled screw. To do this, insert the knurled screw into the hole and then
tighten it.
4. Turn the charcoal barbecue upside down and place it carefully on an
even, stable surface.
5. Turn the stand (11) upside down and carefully insert the screw on the
end of the shaft into the threaded opening in the middle of the bottom of
the charcoal barbecue.
6. Twist the stand (11) clockwise to screw it to the charcoal barbecue.
7. Turn the charcoal barbecue and stand (11) the right way around again.
It is then ready to use.

7.3 Usage

Before using for the first time, clean the stainless steel grate (1) and the grease collection tray/reflector
(6). This removes dust and any packaging residue. For more on this, please refer to the
"Maintenance/cleaning" section on page 42.
When powering the barbecue on for the first time, have the charcoal glow for 30 minutes,
before using it to prepare food.
Minor smoke development can occur when the device is heated first when starting a new
barbecue session. For this reason, the device should be heated for 10 to 15 minutes prior to
preparing grilled food for the first time.
1. Loosen both latches (7) and remove the stainless steel grate (1).
2. Place the device on an even, non-slip and dry surface.
FLORABEST FLG 40 A1
English - 37