Status Led; Intended Use; Approvals - Dräger X-pid 9500 Gebrauchsanweisung

Description
3 Gas inlet (M3 thread)
4 Charger plug (magnetic)
5 Water and dust filter
3.1.3

Status LED

The status LED displays various signals depending on the device and
connection status of the sensor unit and mobile app.
Status LED
Off
Pulsing
Alternating:
Pulsing and
double blinking
On (continuous
light)
Blinking
Flashing
Sequence: lit,
rapid blinking for
2 s and blinking
8 Serial number
9 Name plate
Description
Turned off
Sensor unit is turned off.
Charge
Sensor unit is turned off and is being
charged.
Charged
Sensor unit is turned off and fully
charged. Charging cable is con-
nected.
Connected
Sensor unit is turned on and con-
nected to the mobile app.
Not connected
Sensor unit is turned on, but not con-
nected to the mobile app.
Standby mode
Sensor unit is turned on, connected to
the mobile app and in standby mode.
Connection failed
Sensor unit is turned on, but the con-
nection to the mobile app has failed.
Sequence only for a short time follow-
ing a failed connection attempt.
Status LED
Rapid triple
blinking for 6 s
Rapid blinking
3.2

Intended use

Dräger X-pid 9000/9500 is a portable gas measurement device for continuous
measurement of the total concentration of multiple volatile organic compounds
in Seeker measuring mode and discontinuous measurement of the
concentration of individual hazardous substances in Analysis measuring mode
in ambient workplace air and in explosion-hazard areas.
The intended use of the control unit must also be observed.
3.3

Approvals

The approvals are given on the name plate. A copy of the name plate and the
declaration of conformity are provided in the supplementary documentation
(order no. 9033879) supplied with the Dräger X-pid 9000/9500.
The name plate on the sensor unit must not be concealed.
The approvals only apply to the sensor unit; the approvals for the control unit
must be observed separately.
Description
Sensor unit identified
Sensor unit is connected and the
Blinking button in the Dashboard
mobile app has been pressed to iden-
tify the connected sensor unit.
Charging faulty
Sensor unit is turned off and is show-
ing a charging error. The battery can-
not be charged, e.g. due to the
ambient temperature during charging
or a fault, see "Chapter 5.5 Charging
the sensor unit" for further informa-
tion.