English; Technical Data - IKEA TRÅDFRI Bedienungsanleitung

ENGLISH

ADD LIGHT SOURCES TO YOUR
STEERING DEVICE:
Before you can use your light source you'll need to
pair it with a steering device.
To add more light sources, just repeat the steps
below:
1 Make sure that your light source is installed and
the main power switch is turned on.
2 Hold the steering device close to the light source
you want to add (no more than 5 cm away).
3 Press and hold the pairing button
10 seconds. A red light will shine steadily on the
steering device. Your light source will begin to
dim and finally flash one time to indicate that it
has been successfully paired.
Up to 10 light sources can be paired with 1
steering device.
Make sure to pair them one at a time. If the light
sources are close to each other, disconnect those
that have already been paired from the main
power switch.
CAUTION:
DO NOT USE WITH STANDARD DIMMERS. Only
use the control provided with or specified by these
instructions to control this bulb. This bulb will not
operate properly when connected to a standard
(incandescent) dimmer or dimming control. Only
controllable by IKEA Smart lighting products.
The colour temperature can be switched between
2200K (warm glow), 2700K (warm white) and
4000K (cool white).
RESET YOUR DEVICE
Toggle the main switch 6 times.

TECHNICAL DATA:

Operating frequency: 2405 – 2480 MHz
Output power: 10 dBm
for at least
Manufacturer: IKEA of Sweden AB
Address:
Box 702, SE-343 81 Älmhult, SWEDEN
should be handed in for recycling in accordance
with local environmental regulations for waste
disposal. By separating a marked item from
household waste, you will help reduce the volume
of waste sent to incinerators or land-fill and
minimize any potential negative impact on human
health and the environment. For more information,
please contact your IKEA store.
The crossed-out wheeled bin symbol
indicates that the item should be disposed of
separately from household waste. The item
4