English - IKEA TRADFRI Anleitung

ENGLISH

ADD LIGHT SOURCES TO
YOUR STEERING DEVICE:
Before you can use your light source you'll
need to pair it with a steering device.
To add more light sources, just repeat the
steps below:
1. Make sure that your light source is installed
and the main power switch is turned on.
2. Hold the steering device close to the light
source you want to add (no more than 5 cm
away).
3. Press and hold the pairing button
at least 10 seconds. A red light will shine
steadily on the steering device. Your light
source will begin to dim and finally flash
one time to indicate that it has been
successfully paired.
Up to 10 light sources can be paired with 1
steering device.
Make sure to pair them one at a time. If
the light sources are close to each other,
disconnect those that have already been paired
from the main power switch.
CAUTION:
DO NOT USE WITH STANDARD DIMMERS. Only
use the control provided with or specified by
these instructions to control this bulb. This bulb
will not operate properly when connected to a
standard (incandescent) dimmer or dimming
control. Only controllable by IKEA Smart
lighting products.
With the remote control you can switch
between 9 colours and white lights:
for White tones
Cool white - 4000 Kelvin
Warm white - 2700 Kelvin
Warm glow - 2200 Kelvin
Candle light - 1780 Kelvin
Colours
Amber, Dark peach Dark pink, Light purple,
Light blue
If you add the gateway and the app, you get a
total of 20 colours and white lights:
4