Safety Measures; Shipping Contents; Set Up - Nouvag TCM 3000 Bedienungsanleitung

NOUVAG AG
Your safety, the safety of your team, and, it goes without saying, the safety of your patients is for
Nouvag AG the first priority. It is therefore vital that the following measures be strictly observed:
•
The TCM 3000 should be operated by qualified personnel only!
•
Check for correct operation voltage and verify mains voltage output!
•
Responsibility for the use of sub-units, accessories, parts or assemblies from
other manufacturers rests solely with the user!
•
Repairs are to be carried out by authorized NOUVAG service technicians only!
•
Nouvag AG cannot be held liable for any malfunction of the TCM 3000, or
performance failure and/or its designed or desired utility, nor can Nouvag AG
be held liable for any injuries to persons or animals, in any case when the TCM
3000 is miss-used or not operated, applied or maintained in strict accordance
with the user/owner instructions set out in the operating manual. In the event
of any doubt or question, the user is to contact Nouvag AG or its lawful
representative for clarification or assistance!
1454........................... Control unit TCM 3000, 70:1....................................................................... 1 piece
1775nou..................... Micromotor 31S sterilizable ........................................................................ 1 piece
1066........................... Handpiece support...................................................................................... 1 piece
1488........................... Footswitch On / Off ..................................................................................... 1 piece
or
1487........................... Footcontrol Vario ........................................................................................ 1 piece
1. Connect the footswitch On/Off or Vario-Footcontrol to "FOOT" socket
(→ if using device with pedal)
2. Connect motor to "MOTOR" socket.
3. Attach handpiece or contra angle with instrument to motor.
4. Plug in AC cord to electrical outlet.
5. Turn on green power switch "ON / OFF" (on rear of unit)
6. Select the desired reduction and speed.
7. Press the "Motor" or push the foot plate down to start the motor (if the pedal is connected)
No. 31891 31/05

2 Safety measures

3 Shipping contents

4 Set up

TCM 3000
3