Herunterladen Inhalt Inhalt Diese Seite drucken

Safety Measures; Shipping Contents; Set-Up - Nouvag TCM Endo III Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

NOUVAG AG
Your safety, the safety of your team, and, it goes without saying, the safety of your patients is for Nouvag
AG the first priority. It is therefore vital that the following measures be strictly observed:
The TCM Endo III should be operated by qualified personnel only!
Check the correct operation voltage on the rating plate!
Responsibility for the use of accessories, parts or assemblies from other
manufacturers rest solely with the user!
Repairs are to be carried out by authorized Nouvag AG service technicians
only!
Nouvag AG cannot be held liable for any malfunction of the TCM Endo III, or
performance failure and/or its designed or desired utility, nor can Nouvag AG
be held liable for any injuries to persons or animals, in any case when the
device is miss-used or not operated, applied or maintained in strict accordance
with the user/owner instructions set out in the operating manual. In the event
of any doubt or question, the user is to contact Nouvag AG or its lawful
representative for clarification or assistance!
1520 ........................... Control unit TCM Endo III ...........................................................................1 piece
1823 ........................... Micromotor Endo ........................................................................................1 piece
1488 ........................... On / Off -Footswitch....................................................................................1 piece
1)
Connect On/Off-footswicht to "FOOT"
(→ when operating unit with footswitch)
2)
Connect the micromotor to "MOTOR"
3)
Attach handpiece or contra angle
4)
Attach AC cord into the plug in the back of the unit and the electrical outlet
5)
Turn on green power "ON / OFF" switch (rear of unit)
6)
Adjust desired reduction and speed.
7)
Press "MOTOR"-key or step on the foot switch (if foot switch is connected) to start the micromotor.
No. 31817 29/05

2 Safety measures

3 Shipping contents

4 Set-up

TCM Endo III
3

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis