Attaching The Cover; Removing The Cover - Truma S 3004 Einbauanweisung

S 3004 P only
Connect spade connector of electrode cable (16) to piezo
ignitor (18). Slide earth cable (15) through the recess in the
support and attach to to right (R) or left (L) earth contact of
installation box.
15
16
Fig. 17
Fit cover (62) to support (60) and engage. Ensure that the ca-
bles are routed without kinking and do not become trapped.
Fit control knob (51 – gas) to control rod (7) in such a way that
the mark points to the "0" position.
22
63
23
60
Fig. 18
Fig. B
Clip shield (65) into Mica window recess of cover (right for
right-hand installation and left for left-hand installation).
18
16
15
L
R
51
62
63
50
0
1 5
4
2
3
7

Attaching the cover

Hook cover into the lower bearings (1) and swivel in (2) until
catch audibly engages. Pull to make sure the cover is firmly
attached.
1
Fig. 19

Removing the cover

Do not remove the cover unless the heater is switched
off and has cooled down.
The cover is unlocked by pushing the two locking levers (64)
outwards simultaneously. It can be swivelled out and lifted
from the lower bearings.
64
Fig. 20
2
21