Activating The Timer; Sleep Function; Units Of Temperature Change - Webasto Belaire H2000 Bedienungsanleitung

5.12 Activating the timer

Fig. 34: TIMER Modes
TIMER
Fig. 35: Activating the timer

5.13 Sleep function

SLEEP
Fig. 36: Setting the sleep function

5.14 Units of temperature change

°C/°F
Fig. 37: Celsius / Fahrenheit changeover
Cool Top Trail 20/24
Before activating the timer, select the operation mode, the set
temperature and the desired fan level.
After the start and stop times are set
the three different TIMER modes can be activated:
1. TIMER
In this mode the unit will switch on at the desired ON time
and keep on running.
2. TIMER
In this mode the unit will stop running at the desired OFF time
and will stay off.
3. TIMER
In this mode the unit will start to run at the ON time and stop
running at the OFF time.
This procedure will be repeated every day.
Press the
X
OFF
er mode is preferred. To confirm the selection wait 10 sec-
onds until the symbol stops flashing and lights up perma-
10s
nently.
– The clock time shows again.
NOTE
When only the clock shows and no
the timer is not activated.
The sleep function automatically modifies the target tempera-
ture value to provide a pleasant sleeping temperature. It also
helps to reduce compressor run time and thus energy con-
sumption as well as noise levels.
Press the
X
– The
up to indicate that the sleep function is activated.
– In COOL mode the set temperature will automatically
increase in two steps and it will have inceased by 2°C after
two hours.
– In HEAT mode the set temperature will automatically
decrease in three steps and it will have decreased by 3°C
after two hours.
– The sleep function is only available in COOL or HEAT
mode.
Press the
X
Press the
X
temperature display: Celsius or Fahrenheit.
– You can do this in any mode.
– The display on the air distributor follows the selection
°C/°F
made on the remote control.
ON
mode
OFF mode
ON / OFF mode
key repeatedly until either the
TIMER
or both symbols are flashing depending on which tim-
key to activate the sleep function.
SLEEP
symbol in the display of the remote control shows
key again to deactivate the sleep function.
SLEEP
key to select the temperature units of the
°C/°F
(see chapter 5.11) one of
ON or
OFF
ON or symbol,
16