Installation Of The Adaptor Frame; Installation Of The Outdoor Unit - Webasto Belaire H2000 Bedienungsanleitung

4.6

Installation of the adaptor frame

"This side up"
Fig. 08: Orientation of the adaptor frame
400 x 400
Fig. 09: Sealant paths
Fig. 10: Forming an effective seal
4.7

Installation of the outdoor unit

Fig. 11: Position the outdoor unit
Cool Top Trail 20/24
This side up
360 x 360
Attach and lay the cables so that they cannot be
X
tripped over or damaged.
Use cable ducts to route cables through walls with
X
sharp edges.
Respect minimum cross sections of the cable corre-
X
sponding to the current draw of the unit.
Do not lay the 230 V cables and 12/24 V cables to-
X
gether in the same cable duct.
Do not lay cables which are loose or bent next to
X
electrically conductive material (metal).
Make sure the roof is clean, dry and free from oil or
X
grease.
Insert the adaptor frame into the cut-out to check if
X
the power supply cable is interfering with the frame.
If so, cut or drill an opening into the bottom side of
the frame so that the cable can be led through.
Confirm orientation by starting with the "This side
X
up" label upwards.
Turn the part over and on the reverse side of "This
X
side up", apply silicone sealant uniformly over the
path shown.
Turn the part over again and make sure "This side
X
up" is up. Press down firmly over the installation
hole and remove any sealant that has squeezed out.
Put the outdoor unit over the installed adaptor
X
frame and adjust the position to make sure the four
bolt holes on the corners align.
NOTE
The outdoor unit is heavy. Always have a
second person to help carrying the unit.
Do not lift the outdoor unit by the upper
white cover. Lift it by the bottom base.
Check with the M8 bolts if the holes of the
outdoor unit are aligned with the holes of
the adaptor. If not then reposition the out-
door unit to align the holes.
Do not apply additional sealant between
the outdoor unit and the adaptor frame.
8