Setting The Timer; Activating The Timer - Webasto Cool Top Trail 34 Bedienungs- Und Installationsanleitung

5.11 Setting the timer

SET TIME
2x
HOUR/MIN
SET TIME
HOUR/MIN
or
SET TIME
Fig. 34: Setting the timer

5.12 Activating the timer

Fig. 35: TIMER Modes
TIMER
Fig. 36: Activating the timer
Cool Top Trail 34
The timer can be set to start and stop the unit at a pre-pro-
grammed time. In a first step these start and stop times need
to be set.
X
X
X
X
X
X
10s
X
NOTE
The timer ON and OFF times are now set but not yet activat-
ed.
Before activating the timer, select the operation mode, the set
temperature and the desired fan level.
After the start and stop times are set
the three different TIMER modes can be activated:
1. TIMER
In this mode the unit will switch on at the desired ON time
and keep on running.
2. TIMER
In this mode the unit will stop running at the desired OFF time
and will stay off.
3. TIMER
In this mode the unit will start to run at the ON time and stop
running at the OFF time.
This procedure will be repeated every day.
X
10s
NOTE
When only the clock shows and no
the timer is not activated.
Press the key twice until
SET TIME
right side of the clock and the hour digits are flashing.
Press the or key to set the hour when the unit should
switch ON.
You may also set the minutes by pushing the
using the UP or DOWN keys.
Press the key again until
SET TIME
right side of the clock and the hour digits are flashing.
Press the or key to set the hour when the unit should
switch OFF.
You may also set the minutes by pushing the
using the UP or DOWN keys.
To end the setting mode press the
10 seconds until the digits stop flashing. The clock time is
shown.
ON mode
OFF mode
ON OFF
/ mode
Press the key repeatedly until either the
TIMER
OFF or both symbols are flashing depending on which tim-
er mode is preferred. To confirm the selection wait 10 sec-
onds until the symbol stops flashing and lights up perma-
nently.
– The clock time shows again.
ON shows on the upper
key and
HOUR/MIN
OFF shows on the lower
key and
HOUR/MIN
key again or wait
SET TIME
(see chapter 5.11) one of
ON or
ON or OFF symbol,
17