Setting The Clock; Setting The Timer - Webasto Belaire H2000 Bedienungsanleitung

Fig. 30: HEAT mode
Fig. 31: AUTO mode

5.10 Setting the clock

SET TIME
HOUR/MIN
Fig. 32: Setting the clock

5.11 Setting the timer

SET TIME
2x
HOUR/MIN
SET TIME
HOUR/MIN
or
SET TIME
Fig. 33: Setting the timer
Cool Top Trail 20/24
HEAT mode
C
NOTE
When operating in heating mode in low ambient tempera-
tures the unit will periodically defrost the outside heat ex-
changer. The air distributor will display "df" during defrosting
and then return to heating once the defrost is completed.
AUTO mode
C
C
X
X
X
SET TIME
X
3x
or
X
10s
The timer can be set to start and stop the unit at a pre-pro-
grammed time. In a first step these start and stop times need
to be set.
X
X
X
X
X
X
10s
X
NOTE
The timer ON and OFF times are now set but not yet activat-
ed.
– In HEAT mode the air distributor shows the
the vehicle will be heated.
– Set temperature and fan speed can be selected manually.
– The compressor will switch off once the set temperature is
reached, it will automatically start up again once the room
temperature has fallen below the set point.
– In AUTO mode the unit automatically selects heating or
cooling mode depending on the difference between cur-
rent room temperature and set point temperature.
– Set temperature and fan speed can be selected manually.
– The air distributor shows the
and the symbol in cooling mode as well as the set
temperature.
Press the key so that the hours digits are flashing.
SET TIME
Press the or key to set the hour.
Press the key so that the minute digits are flashing.
HOUR/MIN
Press the or key to set the minutes.
To end the setting mode press the
10 seconds until the digits stop flashing.
Press the key twice until
SET TIME
right side of the clock and the hour digits are flashing.
Press the or key to set the hour when the unit should
switch ON.
You may also set the minutes by pushing the
using the UP or DOWN keys.
Press the key again until
SET TIME
right side of the clock and the hour digits are flashing.
Press the or key to set the hour when the unit should
switch OFF.
You may also set the minutes by pushing the
using the UP or DOWN keys.
To end the setting mode press the
10 seconds until the digits stop flashing. The clock time is
shown.
symbol and
symbol in heating mode
key 3 times or wait
SET TIME
ON shows on the upper
key and
HOUR/MIN
OFF shows on the lower
key and
HOUR/MIN
key again or wait
SET TIME
15