Hafele WT 200 Montage- Und Wartungsanleitung Seite 79

3. Connect the connection leads to the clips of the reader (Fig. 13/1).
It must be noted that the conductor which is connected to A at
the controller is also connected to A at the reader. The same
applies to the conductor which has been connected to B.
Fig. 13: Connections on the back of the WRU 200 reader
4. Screw the accompanying cover to the back of the reader (Fig.
Lead out the leads to the padded cable guides at the side (Fig. 14/2).
NOTE
Risk of damage to the leads!
• Carefully push the reader and leads into the switch box.
• Ensure that the leads are not trapped.
Fig. 14: Back of WR 200 reader with cable
14/1).
79