Changing The Batteries; Technical Data; Led Indicators - GUTMANN PLANEA EM 09 Bedienungsanleitung

EN
The hood moves downwards (7)
By pressing button 7, the
moves out of the ceiling frame down-
wards until end stop. Max. movement
850 mm. By pressing button 7 once
more, the hood remains
position. To move
wards, press the button again.
The hood moves upwards (8)
By pressing button 8, the hood
moves to its original condition into
the ceiling frame and up to the end
stop. The motor will switch off. By
pressing button 8 once more, the
hood remains fixed in position. To
move the hood upwards, press the
button again.

Changing the batteries:

The battery cover is situated on the back
of the remote control. Lift the cover with
thumb and first finger until the magnetic
contact that holds the battery cover re-
leases. Now remove the empty batteries
and replace them with new batteries of
the same type.
Caution: Do not dispose of empty batter-
ies with your normal household waste!

Technical data

Dimensions: 230 x 34 x 10mm
Battery: 2 lithium batteries
Type: CR 2032 3 V
Infrared range: ~ 2m
24
hood
fixed in
the hood up-
Operation via Switch
(Located on the Ceiling Device below the Pane
is an emergency function, not all functions are
available)
Pressing the switch to the left (1) :
Light ON/OFF
Longer push results in dimmed light (not
with LED).
Pressing the switch to the right (2):
fan ON
The filter saturation display is also reset
using this switch. To do so, press the
switch to the right until the red LED
turns off.
Pressing the switch to the right for 3
seconds: hood is turned off.
Regulation of the power level
Push switch (3) at the right side + sym-
bol: higher fan performance
Push switch (4) –symbol:
lower fan performance
In certain cases switch allocation can
differ from the photo due to specific cus-
tomer requirements.

LED Indicators

Information regarding the operating con-
ditions of the hood can be read on the
device's LED indicators:
Indicators
Cool Down
Level 1 green LED
Level 2 green LED
Level 3 green LED
Intensive Level
Filter Saturation Indicator
green LED
green LED
red LED