Operating instructions
The functions of the hood model and
the fan power can be controlled us-
ing two alternative procedures:
Operation
by
(recommended) Item no.: 8001
Operation via switch
Filter Saturation
Button min. ~15 sec.
Pressures to a
LED
goes off !
remote
contro
(Emergency function)
red
ON / OFF (1)
To switch on, press the box with the
ON / OFF symbol. The hood moves
out of the ceiling frame and then
turns the fan on.
press the ON / OFF symbol again.
The hood can also be switched on
by pressing button 2 or 3.
Fan power increase
Press the Fan power increase sym-
bol. With each press, the fan power
increases by one setting.
Fan power decrease
Press the Fan power decrease sym-
bol. With each press, the fan power
decreases by one setting up to set-
ting 1.
Light (4)
If the button is pressed once:
light on LED light on
If the button is pressed twice: Ambi-
ent light off, LED
If the
button is pressed three times: Am-
bient light off, LED light stays on.
If the button is pressed four times:
Both lights are off.
LED lighting not dimmable
Intensive setting
By pressing the Intensive setting button,
the maximum fan power is reached.
After
5
minutes,
switches back by one setting.
Automatic after-run time
By touching the box with the After-run
time symbol (2nd symbol from left), Auto-
matic after-run time is enabled and the
corresponding symbol lights up. The ex-
tractor hood switches back from setting 3
to setting 1 and runs ~15 min. in this
mode before switching off.
The Filter saturation indicator (6) is
likewise reset by pressing (~15 sec.) until
the red LED goes out.
EN
To switch off,
(2)
(3)
Ambient
(5)
the
fan
power
(6)
23