Changing The Batteries - GUTMANN CAMPO II EM 05 Bedienungsanleitung

en

Changing the batteries:

The battery cover is located on the back
of the remote control. Unscrew the Phil-
lips screw and lift it with thumb and in-
dex finger until the magnetic contact
which holds the battery cover is re-
leased. Now remove the empty batter-
ies and replace them with the same
type. Replace the battery cover and
screw it tight. Attention: Dispose of
empty batteries properly !
Technical data remotecontrol
Dimensions: 230 x 34 x 10mm
Battery: 2 lithium batteries
Type: CR 2032 3 V
Infrared range: ~ 2m
Operation via Switch
The control panel Located on the Ceiling
Device below the Pane. The control panel
consists of 2 buttons with 6 LED's. The
exhaust power is controlled over the switch
panel. Among the lighting additional op-
tions are also controlled over the switch
panel by some extractor hoods.
Information regarding the operating condi-
tions of the hood can be read on the de-
vice's LED indicators:
Button
Push
a
1x
a 1x
a 1x long Illumination dimmer function
b > 5 sec.
b 1x
b 2x
b 3x
b 4x
b 3sec.
18
Illumination ON
Illumination OFF
Colour temperature adjustment ( only TW version )
Pressing and holding button (b) will start the color change ( 2700 -
6500K ) and the last value will also be stored when released.
( only available when the engine is stopped )
Hood ON Motor starts at level 1, LED c + 1.
Motor starts at level 2, LED c + 1-2.
Motor starts at level 3, LED c + 1-3.
Motor starts at intensive level, LED c + 1-4.
Motor automatically switches back to stage 3 after 5 min.
Motor switches off
Execution