Operating The Hob With The Sensor Keys; Worth Knowing About The Slider (Sensor Field) - GUTMANN VIENTO 2900 ML Bedienungsanleitung

3.1 Operating the hob with the sensor keys

The glass ceramic hob is operated with touch
control sensor keys. The sensor keys are
operated as follows: lightly touch a symbol on
the surface of the ceramic glass plate. An a-
coustic-signal will indicate when the controls
have been operated correctly.
The sensor key of the touch control is herein-
after referred to as "key".
ON / OFF key (hob) (7)
This key is used to switch the entire hob on
and off.
Cooking zone power setting display
(9-10-11-12)
The power-setting indicator shows the power
setting which has been selected, or:
Residual heat
Power stage
Pot detection
Automatic precooking
Pause function
Parental lock
Bridge function
Heat retention level
Grill function
Error message
Fan power setting display (13)
The power setting display shows the power set-
ting for the fan which has been selected, or:
Automatic blower
Display of the filter status
Error message
Lock key (15)
The lock key can be used to lock all of the
keys.
Keep warm key (16)
To keep warm.
Power boost in the sensorfield
The power boost setting makes additional
power available for induction cooking zones.
Pause key (14)
The Pause function can be used to briefly
stop the cooking process.
Recall function (14) (recovery function)
The most recent setting can be recovered if
the hob is switched off unintentionally.
Grill key (17)
Grill function with a griddle plate for induc-
tion.
PRODUCT DESCRIPTION
3.2 Worth knowing about the slider ( sensorfield)
In principle, the slider functions the same as
the touch controls; the only difference is that
you can put your finger on the glass ceramic
surface and then move it around. The sensor
field recognises this movement and raises or
lowers the display setting (power level) in ac-
cordance with the movement.
The term sensor field is used to mean slider
from now on.
sensorfield
What must be observed when operating
sensor fields?
Your finger should not be placed flat onto the
glass ceramic surface in order to avoid ad-
jacent keys/sensor fields from reacting by
mistake.
Press the sensor field lightly or move y-
our finger around
You can press the sensor field very lightly
with your finger; when this is done the setting
on the display (power level) will gradually
change.
When you put your finger on the sensor field
and then move it to the left or right, the dis-
play setting will
The faster the movement, the faster the
change in the display.
EN
change progressively.
49