Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Remove any side shoots from branches with a large number
of twigs.
How to shred garden and kitchen waste with hight water con-
tent and a tendency to clog
to prevent the machine from clogging, alternate waste with
−
wood containing material.
Do not allow the shredded material to pile up too high in the
area of the ejection opening. This can lead to shredded mate-
rial blocking the ejection channel, and backing up to the filler
opening.
Clean out the filler opening and ejection channel thoroughly if
the machine becomes blocked. Before doing this, switch the
motor off and disconnect the machine from the mains power
supply.
Please do not exceed the maximum branch diameter speci-
fied (cutting fresh wood) for your appliance (∅ see p. 15).
Depending on the wood's nature and freshness the maximum
branch diameter the machine can process may be smaller.
The blades largely pull the material into the machine by them-
selves.
Strong branches may cause overloading. This can be avoided
by pulling them back from time to time.
If the machine is overloaded, a protective motor switch en-
sures that the machine turns itself off automatically.
Turn the shredder on again after about 5 minutes.
−
If you cannot turn on the machine after this waiting time re-
−
fer to „Operational faults".
C
h
a
n
g
i
n
g
t
h
e
b
l
a
C
h
a
n
g
i
n
g
t
h
e
b
l
Remove the mains plug before changing the blades.
Risk of injury to the fingers and hands when carrying out
work on the blade unit. Wear protective gloves.
Open the machine.
d
e
s
a
d
e
s
Fix the blade.
Reduced output
One edge of the knife has become blunt:
Turn knife so that you can use the other edge.
Left-hand thread
All knive edges have become blunt:
Replace with new set of knives (order-no. 382425).
M
a
i
n
t
e
n
a
n
c
e
a
n
d
M
a
i
n
t
e
n
a
n
c
e
a
n
d
•
Each time before starting maintenance work:
− Switch off the motor and pull out the mains plug.
− Wear protective gloves to prevent injury.
The cutters will not come to a standstill immediately after
cut-off. Before starting any service work wait until all parts
are stationary.
Be sure to have removed any tools from the machine after
completion of service work.
•
Generally garden shredders require little maintenance. To
maintain their efficiency and a long life, observe the fol-
lowing:
− Keep vent slits clean and free from obstructions.
− Check the locking screws (tighten where necessary).
− Clean the device after shredding.
c
l
e
a
n
i
n
g
c
l
e
a
n
i
n
g
13
Werbung
Kapitel
Inhaltsverzeichnis
