Storage And Transport; Disposal And Recycling - EINHELL GC-SC 36/31 Li-Solo Originalbetriebsanleitung

(see address on the warranty certificate) if
repair work is necessary.
7.3 Changing the roller (see Figures 15-19)
Be sure to wear work gloves!
Only replace the roller with a genuine Einhell rol-
ler, as this will ensure top performance and safety
under all conditions.
To change the scarifi er roller or the optionally
available aerator roller (Fig. 17/Item D, Art. No.:
34.055.72), proceed as follows: Remove the two
socket head screws (Fig. 15/Item A). Lift the roller
on this side and pull out in the direction of the
arrow (Fig. 16). Pull the holder (Fig. 17/Item A) off
the roller used before and then fi t it to the roller to
be used now. Slide the new roller in the direction
of the arrow (Fig. 19) onto the square-ended drive
(Fig. 18/Item A) and press into the holder (Fig.
19). Use the two socket head screws (Fig. 18/Item
A) to secure the roller again.
Apply grease to the square-ended drive from time
to time so that the rollers can be changed easily.
7.4 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
Replacement cutting unit Art. No.: 34.055.82
Anl_GC_SC_36_31_Li_Solo_SPK9.indb 25 Anl_GC_SC_36_31_Li_Solo_SPK9.indb 25
GB

8. Storage and transport

Storage
Store the equipment and accessories out of
children's reach in a dark and dry place at above
freezing temperature. The ideal storage tempera-
ture is between 5 and 30 °C. Store the machine in
its original packaging.
Transport
•
Switch the machine off and isolate it from the
power supply before transporting it.
•
Fit the shipping protectors, if any.
•
Protect the machine from damage and the
strong vibrations that can occur particularly
when transporting in vehicles.
•
Secure the machine against slipping and tip-
ping over.

9. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
- 25 -
20.09.2018 15:41:36 20.09.2018 15:41:36