Bosch MUM57B224 Professional Gebrauchsanleitung Seite 23

After using the appliance
■ Switch off the appliance with the rotary
switch.
■ Remove mains plug.
■ Remove lid.
■ Press the Release button and
move the swivel arm to
position 2.
■ Take the tool out of the drive.
■ Remove the bowl.
■ Clean all parts, see "Cleaning and
servicing".
Continuous-feed shredder
W Risk of injury
Do not grip the sharp blades or edges of the
cutting discs. Take hold of cutting discs by
the edge only. Before attaching / removing
the continuous­feed shredder, wait until the
drive has come to a standstill and pull out
the mains plug. Do not reach into the feed
tube.
Warning!
The continuous­feed shredder must be
completely assembled before use. Never
assemble the continuous­feed shredder on
the base unit. Operate the continuous­feed
shredder in the indicated operating position
only.
Predetermined breaking point
Figure G:
The built­in predetermined breaking point
protects the drive of the appliance. If an
overload occurs, the drive shaft of the con­
tinuous­feed shredder breaks. However, the
drive shaft can easily be replaced.
A new disc holder with drive shaft is availa­
ble from customer service.
Professional Supercut
reversible disc – coarse / fine
for slicing fruit and vegetables.
Process at setting 5.
Designation on the reversible slicing disc:
"Grob" for the coarse cutting side
"Fein" for the fine cutting side
Warning!
The reversible slicing disc is not suitable for
slicing hard cheese, bread, rolls or
chocolate. Slice boiled, waxy potatoes only
when they are cold.
Reversible shredding disc –
coarse / fine
for shredding vegetables, fruit and cheese,
except for hard cheese (e.g. Parmesan).
Process at setting 3 or 4.
Designation on the reversible shredding
disc:
"2" for the coarse shredding side
"4" for the fine shredding side
Warning!
The reversible shredding disc is not suitable
for shredding nuts. Shred soft cheese with
the coarse side only at setting 7.
Grating disc – medium-fine
for grating raw potatoes, hard
cheese (e.g. Parmesan), cooled
chocolate and nuts.
Process at setting 7.
Warning!
The grating disc is not suitable for grating
soft cheese and cheese slices.
Working with the continuous-feed
shredder
Figure H:
■ Press the Release button and
move the swivel arm to
position 2.
■ Insert the bowl:
Tilt the bowl forwards and then set it
down. Turn anti­clockwise until it locks
into place.
■ Press the Release button and
move the swivel arm to
position 3.
■ Remove drive cover from the drive of the
continuous­feed shredder (Fig. H-5a).
■ Hold disc holder at the lower end,
ensuring that the two tips are face up.
Operation en
23