Comfort Adjustments - Vermeiren Trigo S-line Bedienungshandbuch

3.6

Comfort adjustments

CAUTION
• The following comfort adjustments can be done by the attendant or caretaker. All
other adjustments are done by your specialist dealer (see installation instruction).
• Always keep the swing range of the footrest in mind to prevent bystanders from being
injured or objects from being damaged.
• Make sure that your fingers, clothes, buckles won't get entrapped during adjustment.
3.6.1 Backrest width and support
The backrest of the wheelchair has a suspension system with adjustable Velcro straps,
to adjust the width and flexibility of the backrest.
1. Pull the backrest cushion from the Velcro straps of
the backrest.
1. Loosen the Velcro straps.
2. Pull the respective strap to the desired position.
The tension of the individual belts can be varied
and the desired support of the back can be set.
3. Place the back cushion back over the backrest
starting at the front and ending at the back.
4. Secure the Velcro connections by pressing the cushion against the backrest with your
hand.
5. Make sure that all straps are secured with Velcro.
3.6.2 Backrest height (step adjustment)
1. Remove the back cushion.
2. Push the spring button located on the back of the back frame tube.
3. Move the backrest up/down to the desired height.
4. Make sure that the spring button clicks back in the corresponding hole.
5. Repeat for the other side. Make sure that both sides are set to the same height and
that they are firmly secured.
3.6.3 Push handle height (stepless adjustment)
Fixing lever
1. Turn the push handle lever (40) to loosen it.
2. Move the push handle up/down to the desired height.
3. Secure the handle by tightening the lever(40).
4. Repeat for the second push handle. Make sure that both
handles are set to the same height and that they are
firmly secured.
Risk of injuries and/or damage
11
Trigo S
2019-02
Using your wheelchair
40
EN
NL
PL
CS